The edgewatch process group monitoring commands and associated arguments are as follows:
add attribute regexpr index flags interval 'description' 'action'
setstatus index status
delete index
list
Note: The arguments in bold are string literals that you must type exactly as shown. Others arguments are values that you must enter.
Specifies the regular expression used to find the PID of the process to monitor. Enclose this value in quotation marks if it contains spaces or other special characters.
Specifies the row (index) of the monitor table to use for this entry. Each row in the table is uniquely identified by an index number. Rows 1 through 10 are reserved for internal use by the agent, so the index value must be greater than 10 and unique across the table.
Specifies any additional behavioral instructions for this entry using a hexadecimal flags value (for example, 0x00000001). For a list of available flags, see Process Group Monitor Table Flags.
Specifies how often in seconds the monitoring should occur. For example, the value 30 instructs the agent to monitor this entry every 30 seconds. The value must be a minimum of 30 and a multiple of 30 seconds.
Specifies an arbitrary description (0 to 512 characters in length) of the table entry.
Specifies a command (0 to 2048 characters in length), including the full path and any parameters, to run when a match is found for the process group. If the string is empty, the agent performs no action for this entry.
Note: You can change the default settings for when the agent performs actions. For more information, see the chapter "Agent Configuration."
Specifies the status of the entry, which can be one of the following:
Copyright © 2013 CA. All rights reserved. |
|