Administration Guide › Configuring Resources › Event Forwarding › Configure Windows for SNMP

Configure Windows for SNMP

The SNMP Service and the SNMP Trap Service are installed with Windows, but are not a part of the typical setup. Verify that the SNMP Service and Trap Service are running.

To configure Windows for SNMP

1. Click Start, Control Panel, Administrative Tools, Services.

   The Services dialog appears.

2. Perform one of the following:
   • If SNMP Service and SNMP Trap Service are listed, continue the Event Forwarding configuration.
   • If SNMP Service and SNMP Trap Service are not listed, continue with step 3.
3. Click Start, Control Panel, Add or Remove Programs, and Click Add/Remove Windows Components.

   The Windows Components Wizard dialog appears.

4. Scroll down and select Management and Monitoring Tools, and click Next.

   You are prompted for the Windows installation media.

5. Follow the on-screen instructions to complete the installation.
6. Repeat step 1 to verify that SNMP Service and SNMP Trap Service are running.