Administration Guide › Managing SystemEDGE and Application Insight Modules (AIMs) › How to Configure SystemEDGE and Service Response Monitor Through Policies and Templates › Common Usage of Policy Configuration Functions › Define SystemEDGE Policy Control Settings › Configure Object Aggregation

Configure Object Aggregation

By default, SystemEDGE aggregates monitors into a managed object that contain the same values for the object class, instance, and attribute properties. For example, all monitors with a class of SysHealth, an instance of CPU, and an attribute of SysTime are combined into an aggregate managed object.

You can configure the agent to aggregate objects on higher levels when defining SystemEDGE policy. You can also configure other aspects of agent behavior related to object aggregation and the state management model.

Follow these steps:

1. Click the Resources tab, open the Configure pane, expand Policies, and click SystemEDGE.

   The Available Policies page appears.

2. Select the policy in the Available Policies table.

   The Summary page for the policy appears.

3. Click Control Settings.

   The Controls page appears.

4. Click Aggregate Monitors.

   The Aggregate Monitors page appears.

5. Select one or more of the check boxes to specify aggregation levels.

   These represent higher aggregation levels than the default, up to aggregating all monitors into one top-level agent object. Specifying aggregation levels lets you create a tiered object architecture that propagates status up to the level you specify.

6. Configure the following additional settings, and click Save Policy:

   Send legacy traps for all aggregated monitors

   Specifies whether to send legacy traps for all monitors that make up a managed object. By default, the agent only sends a state change trap for the monitor with the highest severity, even if other monitors in the object experience threshold breaches.

   Execute commands of all aggregated monitors

   Specifies whether to execute action commands for all monitors that make up a managed object. By default, the agent only runs an action command for the monitor with the highest severity, even if other monitors in the object experience threshold breaches.

   Aggregation settings are configured. Apply or reapply the policy for the changes to take effect.

More Information:

Define SystemEDGE Policy Control Settings