Enhancements to Existing Features › Options › Base Product Enhancements › JES2 and JES3 › JES Commands Added

JES Commands Added

The following JES commands have been added:

JESSET

This command provides a set of functions that can take actions against JES jobs. All of the functions are also available as line commands or alterable fields on JES displays.

Commands Enhanced

The following enhancements have been made to existing commands.

JLINES

JES NJE and RJE lines

The command LINES was renamed to JLINES. The line device name has changed from the format LNEnnnnn to LINEnnnnn.

This change could impact internal and external security definitions if LINE devices were secured.

The following synonyms have been defined:

• LINE
• LINES

Support has been added for JES3 1.13 and higher releases.

New JES2 Data Fields

• UserId - The security User ID for the job or output.
• Dest - The output destination for SYSOUT transmitters and receivers.
• SecLabel - The security label of the owner.
• Type - Type of line, NJE or RJE.
• LineLimit - The lower and upper line limits used for job selection.
• PageLimit - The lower and upper page limits used for output selection.
• WorkSelection - The work selection criteria used by the device.
• Disconnect - The disconnection status.
• AutoDisc - The automatic disconnection option.
• Trans - Shows if the line has the transparency feature.
• Compress - Shows if the line has compression capabilities.
• ApplId - The application name used for communication.
• Duplex - Shows if the line is half- or full-duplex.
• Intf - Shows whether the BSC line uses interface A or B.
• ContChr - Shows whether ASCII or EBCDIC control characters are used.
• Speed - The speed of the line.
• Code - Shows whether a BSC line uses code A or code B.
• Resist - The resistance of the line.
• Restart - Shows whether the line will automatically restart.
• RestIntv - The automatic restart interval.
• Connect - The automatic connection option.
• ConnIntv - The automatic connection interval.
• JRNum - The number of job receivers.
• JTNum - The number of job transmitters.
• SRNum - The number of SYSOUT receivers.
• STNum - The number of SYSOUT transmitters.
• RmtShr - Shows whether the RJE line is shared.
• TrcCmn - Shows whether the common trace is active.
• TrcExt - Shows whether the extended trace is active
• Socket - The socket name for TCP/IP lines.
• Secure - Shows whether the socket is secure or not.
• IPName - The IP host name for TCP/IP lines.
• IPAddr - The IP address for TCP/IP lines.
• PortName - The port name for TCP/IP lines.
• PortNum - The port number for TCP/IP lines.
• NETSRV - The NETSRV name for TCP/IP lines.
• Protocol - The protocol used for the line.
• DSecLabel - The device security label.
• System - The operating system name.
• JESName - The JES subsystem name.
• JESVers - The JES version.

Deleted JES2 data fields:

• Programmer
• Notify
• XmitTime
• XmitDate

Commands Renamed (JES)

The JES LINES command has been renamed to JLINES.

The new JLINES command replaces the former LINES command. Use the new JLINES command for displaying the status of communication lines for JES2 and JES3.