There were no authorized classes to display. The security rules determined that no data should be displayed.
An invalid parameter was specified for the command. Check the documentation for valid parameters.
The output data set selected with the DATASET command did not contain data.
The data set number or name <dataset> was not found in the displayed output.
The PREV subcommand was entered but there were no more data sets to display. The first dataset is displayed.
The NEXT subcommand was entered but there were no more data sets to display. The last data set is displayed.
There is no output for the selected job or data set. If the job is executing and the selected data set is open, refreshing will not display new data. Exit and reinvoke the OUTPUT command to get the initial data. Once some data is displayed, refreshing will pick up any new data.
The selected output file has been purged from the system.
The parameter specified with the subcommand <subcomname> was invalid or omitted. Issue the OUTPUT subcommand again, specifying a valid parameter.
There are no authorized output files for the selected job.
The memory resident output cannot be obtained for an executing job because the job cannot be swapped in. The displayed output contains only the output written to the spool. Informational only.
|
Copyright © 2014 CA.
All rights reserved.
|
|