The job number specified with the OUTDES command is invalid. Issue the command again, specifying a numeric job number that is greater than 0.
The data entered for the descriptor contained embedded blanks. Embedded blanks are not allowed for this descriptor. Enter a value without embedded blanks.
The data entered for the descriptor either contained non-numeric data or the numeric value was greater than the descriptor allows. Enter a valid numeric value.
The value entered is not a valid value for the descriptor. The value must start with the numbers 0-9. Enter a new value or clear it to continue.
There were no output descriptors to display for the job.
The output descriptor information for output data set <xxxxxxxx> with data set ID <yyyyyy> was purged. The changes could not be made.
The value entered is not a valid value for the descriptor. Valid characters are #, $, @, the letters A-Z and the numbers 0-9. Also, the value should not start with a number. Enter a new value or clear it to continue.
The value entered is not a valid data set name. Enter a valid data set name or clear it to continue.
The D line command was used on a descriptor that did not contain a value. Clear the line command to continue.
|
Copyright © 2014 CA.
All rights reserved.
|
|