The MAP command or subcommand <comname> is not valid when DAT is OFF.
The MAP command address parameter is required.
The MAP subcommand <subcmd> is not valid when no MAP data is displayed.
The ALTER subcommand of the MAP command is not valid with OPTIONS NODATA in effect. Enter the OPTIONS DATA command and retry the ALTER command.
The named map could not be found. Use the LISTMAPS command to list the names of the maps available.
A mapname parameter is required because no implicit map name could be determined for the indicated address.
A mapname parameter is required because no map is associated with the symbol <symname>.
The MAP command was issued without any parameters. The default address (or current location) corresponded to a symbol or the range of a symbol, but that symbol had no map associated with it. The <mapname> parameter must be specified.
The MAP command was issued for a symbol that does not have any map associated with it.
The MAP command was issued for a symbol that does not have any address value defined for it.
The MAP command was issued for a map that is not associated with any symbol.
Informational only.
Informational only.
Informational only.
Informational only.
Informational only.
Informational only.
Informational only.
Informational only.
Informational only.
The DSA name parameter specified on the MAPDSA command was not 3 characters long. DSA names must be 3 characters long.
DSA storage for module <modname> and DSA named <dsaname> was not found.
This message is logged by the MAPDSA command when it successfully located the requested DSA storage of the module.
The MAPDSA command did not find a DSA map named <mapname> within the MAPLIB member named <mapmbr>.
|
Copyright © 2014 CA.
All rights reserved.
|
|