Messages and Descriptions › All -F- Messages › FILE - LISTFILE Messages

FILE - LISTFILE Messages

FILE002E Invalid job number specified

The job number specified with the LISTFILE command is invalid. Issue the command again, specifying a numeric job number that is greater than zero.

FILE003I <x> line command cannot be processed for this entry

The <x> line command can only be processed for data sets with a status of HELD. Clear the line command to continue.

FILE004I <lcmd> line command cannot be processed. Output is non-selectable

A line command was used on an output data set but the output dataset is in a non-selectable state. The output group that contains the dataset must be released before the dataset can be processed.

FILE005E <code> line command is not valid for a held output dataset

The Hold line command cannot be processed because the data set it already held. Clear the line command to continue.

FILE006E Invalid line command - <code>

The line command <code> is invalid. Check the LISTFILE command documentation for valid line commands. Change the invalid line command to continue.

FILE007E <code> line command is not valid for a nonheld job

The file selected for processing cannot be processed because it is not a held output file. <code> is the line command used. Use the D (delete) and R (release) line commands on held output files. Clear the line command to continue.

FILE008E Load failed for GDDM module, <abend>, <reason>

The GDDM module that displays page-mode output could not be loaded. Be sure the GDDM modules are accessible in a STEPLIB or linklist library.

FILE009E GDDM version <currvers> not supported, <reqdvers> required

The installed version of GDDM <currvers> is not the version required <reqdvers> to display page-mode output. If page-mode output viewing is required, the required of version of GDDM must be installed.

FILE010E Call to GDDM abended - abend code <abend>, reason <reason>

A call to the GDDM module to display page-mode output failed. Note the circumstances in which the error occurred. Contact CA Technical Support.

FILE011E Call to GDDM failed - RC=<rc>, reason <reason1> <reason2>

A call to the GDDM module to display page-mode output failed. Note the circumstances in which the error occurred. Contact CA Technical Support.

FILE012E Page-mode output display not available. TSO or ISPF required

The G or V line command was used in an interface where GDDM services are not available. Use the G or V line command when using the TSO or ISPF interface.

FILE013E Output file is not page-mode output.

The G or V line command was used on an output file that was not a page-mode output file. Use the G or V line command only with page-mode output files.