Messages and Descriptions › All -A- Messages › AMS$ - IDCAMS Command Messages

AMS$ - IDCAMS Command Messages

AMS$001I Display buffer full. Enter IDCAMS with no parameters to continue.

The number of lines produced by the command submitted to IDCAMS exceeded the allowable number of lines. The number of lines allowed for the IDCAMS display buffer is specified by the SET IDCAMSROWS keyword. Enter the IDCAMS command with no parameters to continue execution of the same command.

AMS$002I IDCAMS suspended by ATTN. Enter IDCAMS with no parameters to resume.

The execution of IDCAMS was suspended because of an attention interrupt (ATTN or PA1). Enter the IDCAMS command with no parameters to continue execution of the same command.

AMS$004I <variable> set <value>

Informational only.

AMS$005I IDCAMS processing complete, maximum condition code was <cc>

Informational only.

AMS$006W IDCAMS processing complete, maximum condition code was <cc>

Informational only.

AMS$007E IDCAMS processing complete, maximum condition code was <cc>

Informational only.

AMS$008E IDCAMS processing failed, abend <abndcmc>

Informational only.