The following table shows how the start mode specified using the STC PARM= and PARMLIB MEM= affects the resulting start mode.
|
STC PARM= |
PARMLIB MEM= |
Resulting Start Mode |
|---|---|---|
|
None None None |
None COLD WARM |
WARM COLD WARM |
|
COLD COLD COLD |
None COLD WARM |
COLD COLD COLD |
|
WARM WARM WARM |
None COLD WARM |
WARM WARM WARM |
Note: When you explicitly specify the start mode on the START command or within the PROC, causes the parmlib setting to be ignored.
|
Copyright © 2014 CA.
All rights reserved.
|
|