Scroll the Displays

Use the following commands to scroll the CA SYSVIEW displays:

LEFT
RIGHT
UP
DOWN

You can also issue the TOP and BOTTOM commands to go to the top and the bottom of the display, respectively.

If a display contains more data than can fit on one screen, you can view the additional data by scrolling right. To return to your original position, scroll left.

You can use PF keys or function commands to scroll as follows:

Using PF keys
By default, your PF keys for scrolling commands (LEFT, RIGHT, UP, and DOWN) have been set for how much data to scroll at one time. You can change these settings using the SET SCROLLVALUE command.

For values you can specify for SCROLLVALUE, see the SET command online help.

For more information about how to use the SET command, see SET Command--Change Your Profile in the chapter “Basic Tasks.”
Issuing function commands
To scroll a display using a function command, type the scrolling command at the command line. If you want, you can add parameters to the command. For example, if you would like to scroll down eight lines, you would specify the following command at the command line:
```
DOWN 8
```

To learn about the parameters for scrolling commands, look up the command in the CA SYSVIEW online help. For more information about using online help, see Obtaining Help in this chapter.