Audit Events Component

Enhancements to Existing Features › Components › Audit Events Component

Audit Events Component

The Audit Events component tracks or audits the activities and actions that are performed within the CA SYSVIEW product. The Audit Events component is designed to record activities that alter or change resources.

Commands Enhanced

The following enhancements have been made to existing commands.

AUDITDEF

Audit event definitions.

The command has been enhanced to support the library concatenation.

Changed subcommand syntax parameters:

Export definitions to a specific member of a data set.

Syntax:

EXPORT   member
                dsname(member)

Parameters and descriptions

member - The name of the member to be saved.
dsname - The data set name where the specified member is saved.
The data set name can be specified as a fully qualified data set name or using one of the following special keywords.

Keywords and descriptions

USER - Use the optional data set name that you defined in the user profile for the library type PARMLIB.
Example: USER(member)
SITE - Use the optional site PARMLIB date set that is defined in the system configuration options parmlib member GSVXSYSV.
Example: SITE(member)
SYSTEM - Use the system PARMLIB data set that is defined in the system configuration options parmlib member GSVXSYSV.
Example: SYSTEM(member)
SITESYSTEM|* - Use the optional site PARMLIB data set that is defined in the system configuration options parmlib member GSVXSYSV. If the site data set has not been defined, use the system PARMLIB data set name.
Example:
```
SITESYSTEM(member)
                   *(member)
```

AUDITLOG

Audit event log

The CA SYSVIEW log stream technology that reads and writes from the log streams provides a significant performance boost.

This enhancement provides these benefits:

Reduced the CPU used to read and write from a log stream.
Reduced the elapsed time that is required to read many records from a log stream.

The default and maximum value for the LINES parameter has been adjusted.

Parameter

LINES
New Default: 25,000

New Maximum: 1,000,000

Old Default: 5,000

Old Maximum: 100,000

This LINES value is stored in the user profile. You can change the stored default value by issuing the following command from the desired primary command:
```
OPTIONS LINE nnnnn
```