Messages and Descriptions › All -J- Messages › JSUM - JOBSUM

JSUM - JOBSUM

JSUM001I No match found

No jobs match the parameters specified with the JOBSUM command. Issue another JOBSUM command, or issue the REFRESH subcommand to update the display.

JSUM002E Invalid line command - <linecmd>

The line command <linecmd> is invalid. Check the JOBSUM command documentation for a list of valid line commands. Change the invalid line command to continue.

JSUM003E <linecmd> line command is not valid for a nonheld job

The line command <linecmd> is invalid for a nonheld job. Clear the line command to continue.

JSUM004E <linecmd> line command is not valid for a held job

The line command <linecmd> is invalid for a held job. Clear the line command to continue.

JSUM005E <x> line command is not valid for a job on the <xxxx> queue.

The <x> line command cannot be used for a job on the <xxxx> queue.

Clear the line command to continue.

JSUM006E <linecmd> line command is valid only for an executing job

The line command <linecmd> is invalid for a nonexecuting job. Clear the line command to continue.

JSUM007E The status for job <jobname> has changed

The attempt to change the status of job <jobname> has failed because the current status of the job does not match the status on the display. Enter the REFRESH subcommand to update the display, and try the change again.

JSUM008I Job summary task is not active

The job summary task is not active in the SYSVIEW primary address space. The job summary task collects the information displayed by the JOBSUM command. Start the job summary task by entering the following command:

MVS F &jobname,START JOBS

Where &jobname is the name of the SYSVIEW primary address space.

JSUM009E Cancel with purge option not valid with STC or TSU type

The CP line command is invalid with an STC or TSU job type. The line command can be used only with a batch (JOB) job type. Clear the purge option to cancel the job.

JSUM010E The DP line command must be used to delete protected output

The D line command was used on a job that has protected output. Use the DP line command to delete protected output.

JSUM011E Job <xxxxxxxx> is not executing on this system

The line command used on job <xxxxxxxx> can only be used on jobs that are executing on the current system. Clear the line command to continue.

JSUM012E Job <xxxxxxxx> is held by class and cannot be released individually

The R line command was used on an input queue job that was held by the JES2 $HQ command. Jobs held this way cannot be released individually. Clear the line command to continue. The R line command can be used on the Job Classes display to release the entire job class.

JSUM013I Job summary task is initializing

The job summary task is initializing in the SYSVIEW primary address space. The job summary task collects the information displayed by the JOBSUM command. When the task finishes initializing, the job summary information will be available.