Assemble and Link the JES Configuration Modules (INST0020)

Starting Your Product › How to Configure Without CA CSM › Assemble and Link the JES Configuration Modules (INST0020)

Assemble and Link the JES Configuration Modules (INST0020)

The JES Configuration module contains release specific information about both JES2 and JES3. This information is used to obtain JES data.

Assemble and link a JES Configuration module for each system where CA SYSVIEW is used.

The need to run this job multiple times depends on the combination of systems, and versions of JES2 and JES3. A system with different maintenance levels is considered a unique or different version.

Follow these steps:

Review the INST0020 member in the sysview.SAMPJCL data set to ensure all of the files that the job references are correct.
Create JES2 and JES3 configuration modules by changing the SET statements.
- To create the JES2 Configuration module, change the following SET statements:
```
SET  JES=JES2
SET  MODULE=JES2vrrq
```
- To create the JES3 Configuration module, change the following SET statements:
```
SET  JES=JES3
SET  MODULE=JES3vrrq
```
The name that you specified on the SET MODULE= statement must match the name in the PARMLIB member JES (JES Configuration Names Table).
Submit the INST0020 job.
When all steps in the INST0020 job complete with a condition code of 0, the system has successfully assembled and linked the JES Configuration module.

Note: If any assembly errors occur, contact Technical Support at http://ca.com/support. To see the lines in error, try specifying LIST=YES on the JOFFT macro in the source member.

Important! When running this job at a different operating system level than the target system, modify the SYSLIB concatenation to add volume references to the target SYSRES.