Starting Your Product › How to Configure Without CA CSM › Run the System Information Utility GSVCUTIL (INST0010)

Run the System Information Utility GSVCUTIL (INST0010)

The system information utility GSVCUTIL provides you with a report showing your system during the installation. After you run this utility, use the information to verify your GSVIINST parameter values.

Follow these steps:

1. Review the INST0010 member in the data set sysview.SAMPJCL and verify the files that are referenced in the job are correct.
2. Submit the member INST0010.

   You receive a report with the following information when this job ends with a condition code of 0:

   • z/OS system
   • Subsystem
   • A supervisor call (SVC) table
   • Authorized Program Facility (APF) list
   • The SYSVIEW LMP keys
3. Verify parameter values.
   1. Review the report information.
   2. Compare the parameter values shown on the report with the values you entered to modify and run the INSTALL job.
   3. Modify parameter values if the information is incorrect.

   If the information is correct, the installation can continue.