Starting Your Product › How to Configure Without CA CSM › Run the Dynamic Installation Utility (INST0100)

Run the Dynamic Installation Utility (INST0100)

The dynamic installation utility temporarily installs CA SYSVIEW on your system.

Follow these steps:

1. Review the INST0100 member in the sysview.SAMPJCL data set.
2. Submit the member INST0100.

   The Dynamic Installation program returns the following condition codes:

   0

   Indicates that all functions were performed successfully.

   4

   Indicates that not all functions were performed because some were previously completed. Review the job log for messages.

   8

   Indicates that an error was encountered. Review the job log for messages. If more assistance is required, contact Technical Support at http://ca.com/support.

3. Be sure that the job ends with a condition code of 0 or 4.

   CA SYSVIEW is installed on your system temporarily.