The CA SYSVIEW components that you want to install are listed in the following table. After a component is installed, enable it as a COMPONENT value. The table includes the LMP codes and COMPONENT values you specify during the installation to enable a component. The table also includes installation and customization requirements for each component.
Note: To customize components, follow the procedures in the Administration Guide.
|
Component |
COMPONENT Value |
LMP Code |
Installation and Customization Requirements |
|---|---|---|---|
|
CA MIM |
MIM |
FU |
Complete the installation process. No additional installation or customization is required. |
|
CA Roscoe |
ROSCOE |
FU |
Complete the installation process. Note: For information about installing the CA Roscoe monitor, see the Administration Guide. |
|
CA SYSVIEW for CA Insight for DB2 |
DB2 |
IE |
Complete the installation process. No additional installation or customization is required. Note: For information about configuring the component CA SYSVIEW for CA Insight for DB2, see the Administration Guide. |
|
Cross-System |
XSYSTEM |
FU |
Review the XSYSTEM and SYSNAMES parmlib members and complete the installation process. No additional installation or customization is required. Note: For the list of parmlib members and components for which they are valid, see the Administration Guide. |
|
USS |
USS |
FU |
Complete the installation process. No additional installation or customization is required. |
|
IBM Health Checker |
HCHECK |
FU |
No additional installation or customization is required. |
|
Copyright © 2013 CA.
All rights reserved.
|
|