Starting Your Product › How to Configure Without CA CSM › Assemble and Link the JES Configuration Modules (INST0020)

Assemble and Link the JES Configuration Modules (INST0020)

The JES Configuration module contains release specific information about both JES2 and JES3. This information is used to obtain JES data.

You must assemble and link a JES Configuration module for each system where CA SYSVIEW is used.

You may need to run this job multiple times depending on the combination of systems, and versions of JES2 and JES3. A system with different levels of applied maintenance is considered a unique or different version.

To assemble and link the JES Configuration module

1. Review the INST0020 member in the sysview.SAMPJCL data set to ensure that all of the files referenced in the job are correct.
2. Create JES2 and JES3 configuration modules by changing the SET statements.
   • To create the JES2 Configuration module, change the following SET statements:

     SET  JES=JES2
     SET  MODULE=JES2vrrq
     

   • To create the JES3 Configuration module, change the following SET statements:

     SET  JES=JES3
     SET  MODULE=JES3vrrq
     

   The name specified on the SET MODULE= statement must match the name specified in the PARMLIB member JES (JES Configuration Names Table).

3. Submit the INST0020 job.

   When all steps in the INST0020 job complete with a condition code of 0, the system successfully assembled and linked the JES Configuration module.

Note: If any assembly errors occur, contact Technical Support at http://ca.com/support. To see the lines in error, you may need to specify LIST=YES on the JOFFT macro in the source member.

Important! If you are running this job at a different operating system level than the target system, you must modify the SYSLIB concatenation to add volume references to the target SYSRES.