|
|
|
The following CA products integrate with CA SYSVIEW:
Through an interface with CA NSM, you can use the CA SYSVIEW data collection function. This interface uses TCP/IP communication technology.
When CA Service Desk is installed, you can allow CA SYSVIEW to open CA Service Desk requests for unexpected product ABENDs. This capability provides your organization with an immediately recorded notification of the identified problem. You can then address the situation before it causes more serious problems with CA SYSVIEW that could affect the ability to monitor system performance.
Note: For installation information, see the CA Service Desk documentation.
When CA OPS/MVS is installed, CA SYSVIEW can send event notifications to CA OPS/MVS.
CA SymDump System uses CA SYSVIEW technology to generate diagnostic reports during dump capture. Output from any CA SYSVIEW command can be captured and written to the dump data set for later viewing. Using report control statements in the CA SymDump System library, you can control exactly which reports are produced for each type of dump. CA SymDump System communicates with CA SYSVIEW using the GSS component of CA Common Services for z/OS. Install GSS before capturing or viewing dumps.
CA SYSVIEW integration with CA APM provides the following:
CA SYSVIEW extends CA APM Transaction Tracing into CICS. This increases end-to-end visibility for quickly isolating transaction performance problems.
The Dashboard integration between CA SYSVIEW and CA APM brings mainframe statistics and metrics into the CA APM bus to enable a side-by-side view of data from the mainframe and other managed platforms.
| Copyright © 2012 CA. All rights reserved. |
|