Adapter for Cisco IPSec VPN Configuration Guide › Performing Post-Installation Tasks › Checking RADIUS Protocol Support in AuthMinder Server

Checking RADIUS Protocol Support in AuthMinder Server

By default, AuthMinder is enabled to process RADIUS requests. You can use Administration Console to verify the RADIUS protocol status.

Before proceeding with the steps mentioned in this section, ensure that AuthMinder Server and Administration Console are successfully installed and configured.

To verify RADIUS protocol support in AuthMinder Server:

1. Log in to Administration Console as a Master Administrator by using the following URL:

   http://App_Server_Host_Name:Port_Number/arcotadmin/masteradminlogin.htm

   In the preceding URL, App_Server_Host_Name indicates the host name or the IP address of the application server where you configured Administration Console and Port_Number indicates the port at which the server listens to incoming requests.

2. Click the Services and Server Configurations tab.
3. Activate the WebFort tab.
4. Under the Instance Configuration section on the side-bar menu, click the Protocol Management link.

   The Protocol Configuration page opens.

5. In the List of Protocols table, click RADIUS.

   The RADIUS page opens.

6. Ensure that the Protocol Status field is set to Enabled.

   If the protocol is not enabled, then perform the following steps.

7. Select the Change Protocol Status check box.
8. From the Action drop-down list, select Enable.
9. Click Save to save your changes.
10. Restart AuthMinder Server.

You have enabled RADIUS protocol support in AuthMinder Server.