CA Adapter Juniper SSL VPN Configuration Guide › Performing Post-Installation Tasks › Configuring AuthMinder › Enabling RADIUS Protocol Support in AuthMinder Server

Enabling RADIUS Protocol Support in AuthMinder Server

You must use the AuthMinder Administration Console to enable RADIUS protocol support. You must do this after you have successfully configured AuthMinder Server and the AuthMinder Administration Console.

To enable RADIUS protocol support in AuthMinder Server:

1. Log in to AuthMinder Administration Console as Master Administrator by using the following URL:

   http://host_name:port_number/arcotadmin/masteradminlogin.htm

   In the preceding URL, host_name indicates the host name or the IP address of the application server where you configured Administration Console and port_number indicates the port at which the server listens to incoming requests.

2. Click the Services and Server Configurations tab.
3. Activate the WebFort tab.
4. Under Instance Configurations in the side-bar menu, click Protocol Management.

   The Protocol Configuration page opens.

5. In the List of Protocols table, click RADIUS.

   The RADIUS page opens.

6. Select the Change Protocol Status check box.
7. From the Action drop-down list, select Enable.
8. Click Save to save your changes.

You have enabled RADIUS protocol support in AuthMinder Server.