The Tabular Report provides statistics summarized by classes of metrics. These classes include CPU, DISK, IO, LOCK, MEMORY, PAGING, PROCESS, SCS, and CACHE. The report classes are accessed by using the SECTION qualifier.
The sections include the following classes:
Overview section listing node, collection interval and reporting interval information
Presents classes CPU, IO, LOCK, MEMORY, PAGING, SCS, and CACHE.
Presents the DISK metrics class.
Presents the PROCESS metrics class.
Because the Tabular Process Metrics displays the information by PID, IMAGENAME, PROCESSNAME, ACCOUNT, and USERNAME, you must specify all these key levels when selecting data in either command mode or via the DECwindows interface.
The Tabular report can be requested in either a final form, which presents the data summarized over the entire reporting period specified, or in an interval form, which presents a series of sub-reports for the reporting interval specified. For example, if the overall time period indicated by the /BEGIN and /END qualifiers is one hour, and the /INTERVAL qualifier is used with a value of 600 seconds, each requested report section is produced 6 times, summarizing successive 10 minute periods.
The Interval reports (all sections) are available from the DCL command line interface. Command mode does not provide access to the Interval reports. The DECwindows Motif interface allows viewing of interval data with the exception of the Process Section.
Examples of final tabular reports are shown in the following sections.
To display the Tabular Report, specify the ADVISE PERFORMANCE REPORT TABULAR command.
|
Copyright © 2008 CA.
All rights reserved.
|
|