This command displays the most frequently accessed files on a disk.
ADVISE COLLECT DISPLAY FILES
Use the ADVISE COLLECT DISPLAY FILES command to display hot file activity on your screen. While displaying file activity, you can enter commands to control the display and its characteristics. The following table describes the File Activity display interactive subcommands.
|
Subcommand |
Meaning |
|---|---|
|
EXIT or CTRL+Z |
Exits from the display |
|
HELP |
Displays HELP information for field descriptions and subcommands |
|
SET DISK |
Defines the disks for which statistics are displayed |
|
SET INTERVAL |
Defines the rate at which disk statistics are displayed |
|
SHOW DISK |
Shows the names of disks for which statistics are displayed |
|
SHOW INTERVAL |
Shows the value of the current display interval |
|
SHOW ALL |
Shows the value of the current display interval and the names of disks for which statistics are displayed |
|
SPAWN |
Spawns a subprocess |
|
WRITE [file-spec] |
Copies the screen contents to a file. If no file is specified, the default of PSDC$DISPLAY_FILES.RPT is used |
For more information, see the chapter Display File Activity.
Specifies the disks on which you wish to monitor file activity with either the physical device name or equivalent logical name. If you do not specify the /DISK qualifier, Performance Agent displays file activity on SYS$SYSDEVICE.
Specifies the interval at which file activity is displayed. The /INTERVAL value must be in the range of 1 to 3600 seconds. If you do not specify an interval, the default value is 10 seconds.
$ ADVISE COLLECT DISPLAY FILES/DISK = $1DUA7/INTERVAL = 120
|
Copyright © 2008 CA.
All rights reserved.
|
|