VSAMPFX=x

x is concatenated before the standard data set name for CA‑PanAPT files. Change this to your site's high‑level VSAM index.

none

OTHRPFX=x

x is concatenated before the standard data set name for CA‑PanAPT files. Change this to your site's high‑level sequential index.

none

MMPCCPFX=x

x is concatenated before the standard data set name for CA‑PanAPT files and after the high-level sequential index that contains the control members for a Move Processing Cycle. x must be a 1 to 8 character standard IBM data set qualifier.

'M'

SYSDA=x

x indicates the disk type.

SYSDA

STATUS=x

x if specified must be an abbreviated Move Request status, such as 'APP' or a list of statuses, such as 'APP,SLP,APP‑B,SLP‑B', to be used as selection criteria. Only Move Requests in the specified statuses are selected. If no statuses are specified, then Move Requests are not selected by status, other than the requirement that Move Requests must be approved or selected for a move or back out.

ST-OMIT=x

x if specified must be an abbreviated Move Request status, such as APQ or a list of statuses, such as APQ,SLQ,APQ‑B,SLQ‑B, to be used as omission selection criteria. Any Move Requests in the specified statuses are omitted from selection, even if they pass all other selection criteria. If no statuses are specified, then Move Requests are not omitted by status.

MPC=x

x specifies a list from 1 to 36 characters that is used to select Move Requests for processing during this Move cycle. Code the list with the values that are used in the Move Type of a Move Request to control Move Processing Cycles.

'M'

JCLLIST=x

x must be suitable to be included in SYSOUT=x. Utility messages, control totals, and so forth are routed to this destination.

*

REPORTS=x

x must be suitable to be included in SYSOUT=x. Output reports are routed to this destination. Change this in the JCL to your site's standards.

*

DUMPS=x

x must be suitable to be included in SYSOUT=x. SYSUDUMP output is routed to this destination.

*