If you cannot remember the name of a Library Code while you are using CA‑PanAPT, you can display a list of all Library Codes. This is done by typing LC on the Command Line and pressing ENTER. This can be done from any panel, except when you are in Library Code maintenance or while setting up the CA‑PanAPT User Identification Facility (UIF).
You can scroll through the list using the UP and DOWN commands (PF7 and PF8). If you have several Library Codes, you can use the LOCATE command to position the list to that Library Code. To use the LOCATE command, enter LOCATE or L on the Command Line followed by the Library Code name. If a Library Subcode is specified, the Library Code must include a slash (/), and there should be no embedded spaces. If you want, you can leave off the Library Subcode.
You can view the contents of a Library Code by entering I or INQ for the action and pressing ENTER. CA‑PanAPT takes you into an inquiry of the Library Code using Library Code maintenance (described earlier in this chapter). When the inquiry is done, you return to the Library Code Selection List panel.
If you entered the LC command from a panel where a Library Code had to be specified, in most cases you can select a Library Code from the list. CA‑PanAPT returns you to the panel where you entered the LC command and enter the Library Code name for you.
To exit out of the Library Code Selection List panel enter the END command (PF3). You then return to the panel where you entered the LC command.
|
Copyright © 2004 CA.
All rights reserved.
|
|