Implementation › Phase One: System Familiarization › User Preparation and Planning › Performing Phase One Using CA PanAPT

Performing Phase One Using CA PanAPT

CA PanAPT

Continue Phase One by following these steps:

1. The designated administrator uses CA‑PanAPT to add users. For this phase, keep the default activity authorities.

   Note: After adding at least one user as system administrator, change the *DEFAULT user ID so that it no longer makes everyone an administrator.

2. The designated administrator modifies the System Information records.
3. Run Job APJJ5103 in JCLLIB to print your updated Control file records. Review these to be sure you understand the report and what you did.
4. The designated administrator adds the Library Code, using the Library Code Set‑up Form as input.
5. Run Job APJJ5102 in JCLLIB to print the Library Code file. Review this report to be sure you understand the report contents.
6. Create your two planned Move Requests using CA‑PanAPT.
7. Retrieve the members where Retrieve is enabled.

   Note: Steps 10 and 11 can be performed in either order.

8. Review your Move Requests, change as needed. Print the Move Requests.
9. Close the Move Requests. Print the Move Requests.
10. Approve the Move Requests.
11. Run Job APJJ5310 in JCLLIB to select the Move Requests.
12. Run Job APJJ5320 in JCLLIB to move the members in the selected requests.
13. Review all reports, submit and review any others you feel are appropriate and informative.
14. Back up the CA‑PanAPT files using the Job APJJBKUP in JCLLIB.