Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL

How to Install Products Using Native SMP/E JCL

The following steps describe the process to install products using native SMP/E JCL:

1. Allocate product data sets and SMP/E data sets.
2. Create SMP/E CSI.
3. Receive base functions.
4. Apply base functions.
5. Accept base functions.
6. Configure the product according to your site requirements.

Note: The CA PMA Chargeback product can be installed in either of two ways: you can install the full product including JARS/OLF, or you can install CA PMA Chargeback base only without JARS/OLF. The path you choose determines the value of pre in the following installation steps:

• Substitute AWF for pre if you are installing the full product including JARS/OLF (for example, AWFSEDIT).
• Substitute AJR for pre if you are installing only the base CA PMA Chargeback without JARS/OLF (for example AJRSEDIT).