Installing Your Product Using Pax ESD or DVD › Generate and Run the Installation Jobs

Generate and Run the Installation Jobs

The installation process creates the dsnpref.OWC2.INSTDB database to store details of each installation that you perform.

Note: During this task, the INSTALLATION JCL Library Creation panel lets you specify your installation JCL library. The default library name is dsnpref.OWC2.INSTALL.JCL, where dsnpref is the same data set prefix that you used for the dsnpref.OWC2.CC2DJCL data set.

If your installation JCL library exists, take one of the following actions:

• Specify a new data set name at that panel.
• Delete the existing library by issuing a TSO DELETE command.

Note: If you leave the Install Utility at any stage, you can return to it from the ISPF/PDF TSO Command Shell prompt. Execute the following command: EXEC 'dsnpref.OWC2.CC2DJCL(INSTALL)'

During the installation process, you provide the site-specific installation information that you previously collected. This information is used to generate the installation JCL.

Follow these steps:

1. At the ISPF/PDF TSO Command Shell prompt, execute the following command:

   EXEC 'dsnpref.OWC2.CC2DJCL(INSTALL)'
   

   The Install Utility panel appears.

   Note: On each of the Install Utility panels, you can use the following keys:

   • Enter to proceed to the next panel
   • F1 to display online help
   • F3 to return to the previous panel
   • F4 to exit and return to the main menu
2. Press Enter.

   The Install Utility Primary Menu panel appears.

3. Enter 1 (Set Installation Parameters).

   The Software Delivery Method panel appears.

4. Complete each of the panels as they open. Press Enter at the completion of each panel.

   Important! During the installation, consider using the target and distribution zone names of CAIT80 and CAID80. Do not use the same zone names as those names used for any of the following software: Chorus, CMDB Connector, Hardware Interface Service, Mainframe Connector, NetMaster, or SOLVE.

   Complete the parameter panels before you install the product. Take the default options, or specify site-specific values.

   Note: For information about the fields, press F1 (Help).

5. Enter 2 (Install Products).

   The INSTALLATION Primary Menu panel appears.

6. Enter 1 (Select Products to Install).

   The INSTALLATION Product Selection panel appears.

7. Enter S next to the product name.

   The INSTALLATION Product Confirmation panel appears, confirming your selection.

8. Press Enter to confirm your selection, and complete each of the INSTALLATION panels as they open.

   Complete all the panels. Take the default options, or specify site-specific values.

9. Record the data set name into which the JCL was generated in your post-installation worksheet.

   You can submit the jobs from the panel or directly from this data set after exiting the panel.

10. Submit and run the following installation jobs in sequence. Do not proceed with any job until the previous job has completed successfully.

    I01ALLOC

    Allocates the data sets.

    The I01ALLOC member allocates CC2DPLD as a load library of the PDSE type.

    I02INSMP

    Initializes the SMP/E data sets.

    I03RCSMP

    Performs an SMP/E RECEIVE.

    I04AKSMP

    Performs an SMP/E APPLY CHECK. This job is listed only if maintenance exists.

    I05RSSMP

    Performs an SMP/E RESTORE. This job is listed only if maintenance exists.

    I06APSMP

    Performs an SMP/E APPLY.

    I07ACSMP

    Performs an SMP/E ACCEPT.

11. Press F3.

    You are returned to the Primary Menu panel.