This health check checks to see if the high level qualifier for the rule data set name is ‘SYS1’. This condition can cause potentially high overhead. This condition is checked once, and reports a medium-severity health check exception if the HLQ ‘SYS1’ is detected.
Specify a less common high-level qualifier for the value of the RULEPREFIX parameter that is consistent with your data set naming standards. Avoid the familiar system prefix ‘SYS1’.
No
No
No
For more information, see the section Setting a Prefix and Suffix for Rule Sets in the Installation Guide.
For more information on the RULEPREFIX command, see the Command and Function Reference.
See the Messages Reference and the chapter "Migration and Upgrade Considerations" in the Installation Guide.
|
Copyright © 2014 CA.
All rights reserved.
|
|