When CA OPS/MVS copies are running on two or more systems and communicating through the CA OPS/MVS MSF or CAICCI cross-platform communications services, you can edit a relational table residing on a remote system using the table editor on the local system.
To edit a table on a remote system, you specify both the system name and the table name on the RDF Table Editor Primary Panel. Separate the system name and the table name with a greater-than symbol (>) instead of a blank, like this:
systemname>tablename
You can specify the ? and * characters instead of a specific system name. The following list shows how to use these characters as wildcards:
Enter the name of that table.
Enter an asterisk (*), or leave the Name field blank. In response, you see a panel listing available tables.
Enter the name of the system followed by the greater-than symbol (>) and the table name, as shown here:
sysname>tablename
Enter the characters ?>* or ?>(blank)
In response, you see a list of systems running CA OPS/MVS. To select one or more systems, type S beside the system name or names.
Note: You cannot select systems whose status is not active.
Result-You see a list of all relational tables on the selected systems.
Enter the following text: ?>tablename
This text causes the table editor to display a list of systems running CA OPS/MVS. After you choose one or more systems, the table editor displays a list of all tables on the selected systems that have the name tablename.
Enter any of the following character sets:
(blank)>(blank)
(blank)>*
*>(blank)
*>*
Enter one of the following:
(blank)>tablename
*>tablename
This text displays a list of all tables with the specified name without displaying a list of systems.
Enter one of the following:
sysname>(blank)
sysname>*
Copyright © 2014 CA.
All rights reserved.
|
|