Parameters › Miscellaneous Operating Parameters › PERMDEBUG Parameter

PERMDEBUG Parameter

This parameter is a debugging tool. It is not intended for general customer use; rather, it should only be used under the direction of a CA Customer Support representative.

Note: The value of the PERMDEBUG parameter will not change for the life of the IPL (even if the product terminates) unless it is explicitly changed through the OPSPRM or OPSPARM function.

Default value

X'00000000'

Other possible values

Any valid four-byte hexadecimal value

Set or modify this parameter…

Anytime

Example: PERMDEBUG

This function sets PERMDEBUG to its default value.

OPSPRM("SET","PERMDEBUG","X'00000000'")