Parameters › OPSLOG Parameters › ARCHIVETRIGGER Parameter

ARCHIVETRIGGER Parameter

This parameter sets the number of messages that CA OPS/MVS accumulates before issuing message OPS4403O, which you can use to trigger the archive job or restart a failed archive (through a message rule).

Note: Use this formula to determine the approximate storage capacity (in bytes) that is required to contain an archived OPSLOG:

The value of ARCHIVETRIGGER * 375

This value may be too low if most of the messages in the OPSLOG are long (close to 128 bytes in length).

Default value: 0

Note: If you use the default, the OPS4403O message never appears.

Other possible values:

Any number between 0 and 1000000000

This value should be smaller than (about half the size of) the value of the BROWSEMAX parameter so that the archive has time to complete before the OPSLOG wraps.

Set or modify this parameter...

Anytime

Example: ARCHIVETRIGGER

This function triggers the archive job after 50000 messages.

OPSPRM('SET','ARCHIVETRIGGER','50000')