OPSVIEW Control Option › How to View Monitored Resource Information (Option 4.11.2) › Primary Commands for the SSM Resource Status Panel

Primary Commands for the SSM Resource Status Panel

Enter primary commands in the Command field. You can issue the following primary commands from the SSM Resource Status panel:

AUTO nn

Places the panel in automatic refresh mode. The value of nn indicates how many seconds CA OPS/MVS waits before refreshing the panel. The minimum value of nn is 5; the maximum is 600. The default is 60 seconds.

Typically, you should place the panel in automatic refresh mode only if you set the View field to EXC. For more information, see How to Change the View Mode of the SSM Resource Panel in this chapter.

To exit from automatic refresh mode, press the ATTENTION key.

CANcel

Ignores any updates or line commands entered on the panel and reconstructs the display with the current resource data.

FILter

Displays the SSM Resource Filters panel to change the filter values that limit which resources are displayed. You can also invoke this command by placing the cursor under the Filtered field near the top of the panel and pressing Enter.

TLeft

Displays the previous panel of the display. You can also invoke this command by pressing the PF10 key.

TRight

Displays the next panel of the display. You can also invoke this command by pressing the PF11 key.