OPSVIEW Control Option › How to View and Control Enabled (In Storage) Rules (Option 4.5.3) › Primary Commands for the Source Display

Primary Commands for the Source Display

Issue primary commands at the command line. You can use the following primary commands on the source display:

UP/DOWN/LEFT2/RIGHT2

Positions the source display up, down, left, or right by using the PF7, PF8, PF9, and PF10 keys respectively.

SAVE

Sends the displayed source code to a PDS member. If you issue a SAVE command, the Save to PDS panel appears and you can fill in the blanks to specify what data set name and member name should be used.

Following is a sample Save to PDS panel:

- MSI1 - Save to PDS   - OPSS -------------------------  
Command ===>                                 Scroll ===> CSR

Data set: 
Member:

Data set and member can be entered together, as in MYDATA.SET(MEMNAME), or they can be entered using the two lines provided. A member name provided on the member line overrides a member name provided on the data set line. You can enclose the data set name in single quotes to designate a fully qualified data set name. The member must not exist in the target data set. Issuing the SAVE command does not overwrite an existing member.