To use a line command, enter it in the SEL column next to the action command keyword. The following line commands perform operations on the SSM action text units.
Displays the line command selection panel. All valid line commands are listed in the panel and are point-and-shoot enabled.
Deletes an action text unit command. No confirmation is requested.
Inserts a new action text unit blank line after the current line.
Inserts the new action text unit line before the current line.
Inserts an SSM built-in variable name or resource table column name at the point in the text unit line where the cursor is positioned. A popup panel is displayed for selection of a valid variable or column name that is appropriate for the SSM process event name of the action. The resource table name used for column names may also be selected on this panel.
Repeats the current action text unit as a new line after the current line.
Changes multiple blanks between text to a single blank. This command provides the correction for data entry of new text anywhere on the line.
Splits the line of text at the cursor position onto a new line.
Joins the text of the current and following line.
Converts the text of the line to lower case from the current cursor position to the end of the line. This command is ignored if the action text column is defined as upper case only.
Converts the text of the line to upper case from the current cursor position to the end of the line.
|
Copyright © 2014 CA.
All rights reserved.
|
|