Enter the new value over the appropriate Current State or Desired State field and press Enter.
If you change the value in a state field, make sure that the new value you are specifying is valid. For example, if a resource is up and you set the Desired State field to down, an action for UP_DOWN must be defined in the action table for that resource. Otherwise, the System State Manager will not be able to find the proper action routine that is needed to change state of the resource, and the resource will hang.
Note: For descriptions of the S, U, and Z line commands, see Line Commands for the SSM Resource Control Panel in this chapter.
|
Copyright © 2014 CA.
All rights reserved.
|
|