OPSVIEW Control Option › How to Modify the Value of a Subnode

How to Modify the Value of a Subnode

This section describes how to modify the value of a subnode.

From the Display Global Variables panel, you can modify the value of subnode using the following methods:

• If the current value of the subnode is short enough to fit in the Subnode Value field on the Display Global Variables panel, and the new value you want to assign to the subnode is also short enough to fit in the field:

  Then type the new value directly over the current value. When you press Enter, the change takes effect.

• If the current value of the subnode is too long to completely fit in the Subnode Value field on the Display Global Variables panel, and you try to enter the new value directly over the current value:

  Then the system displays the Display Global Variables-Modify Value panel. For details, see The Display Global Variables-Modify Value Panel in this chapter.

• If you enter the M command on the line that names the subnode whose value you want to modify:

  Then the system displays the Display Global Variables-Modify Value Using the Line Command panel. For details, see The Display Global Variables-Modify Value Using Line Command Panel in this chapter.