OPSVIEW Control Option › How to Use the AOF CTRL Rule List Panel › Line Commands for the AOF CTRL Rule List Panel

Line Commands for the AOF CTRL Rule List Panel

Issue line commands from the prefix area of the line that names the desired rule.

You can use the following line commands on the AOF CTRL Rule List panel:

A

Sets the auto-enable flag for the rule to Y.

C

Compiles the rule into the compiled rule data set.

D

Disables a previously enabled rule.

E

Enables a rule.

R

Selects an EasyRule-created rule for modification using EasyRule.

S

Selects a rule for modification using the ISPF editor.

V

Selects a rule for viewing instead of using the ISPF viewer.

X

Deletes the rule from the compiled rule data set.

Z

Resets the value of the AE field of the rule to N.

Point-and-shoot is enabled to issue the S line command for any displayed Rule. To issue the S line command for a displayed Rule using the point-and-shoot method, place the cursor to the left of the Rule Name and press Enter. Point-and-shoot is enabled only if no primary or line commands have been entered.

Note: When a rule is selected for EDIT, through either the S primary command or the S line command, and the rule is in EasyRule format, the following warning message is issued:

************************  W A R N I N G *************************
* You are about to edit an AOF rule that is in EasyRule format. *
* You may only add user-written REXX code to an EasyRule format *
* rule between the special EasyRule generated comments.         *
* If you change the member in any other way, you will not be    *
* able to use EasyRule to edit it in the future.                *
************************  W A R N I N G *************************