OPSVIEW Utilities Option › How to Manage the OPSLOG Archive Tracking System (Option 7.1.4) › Line Commands for the Archive Tracking Entries Panel

Line Commands for the Archive Tracking Entries Panel

The following line commands can be used on the Archive Tracking Entries panel. Issue line commands in the prefix area of the line naming the archive.

D

Deletes an entry from the archive tracking system. The setting of the Action Verification field on the OPSVIEW General Settings panel affects the outcome of the D line command:

• If the Action Verification field is set to Y, CA OPS/MVS requests confirmation before it deletes the entry. Press Enter to confirm the request or enter the CANCEL or END command to cancel the request.
• If the field is set to N, CA OPS/MVS deletes the entry without requesting your confirmation.

For details about the OPSVIEW General Settings panel and the Action Verification field, see the chapter “Using the OPSVIEW Parameters Option.”

R

Accesses option 7.1.3, where you can restore the archived OPSLOG. For information, see How to Restore an Archived OPSLOG (Option 7.1.3) in this chapter.

Point-and-shoot is enabled to issue the R line command for an OPSLOG archive. To issue the R line command for an OPSLOG archive using the point-and-shoot method, place the cursor to the left of the desired OPSLOG archive and press Enter. Point-and-shoot is enabled only if no primary or line commands have been entered.