The ISPTCM module that contains the CA OPS/MVS command processors can be loaded from a STEPLIB, linklist, or LPALIB. However, if your CA OPS/MVS command processors are loaded from a STEPLIB or a linklist, they must not also be in the ISPTCM load module used by the system.
However, different scenarios could exist, specifically for testing a new release of CA OPS/MVS. For instance, you could establish the following scenarios:
Note: Because the ISPTCM table can be in a STEPLIB, a linklist, or an LPALIB, a different version of it could exist in each of these places at the same time. If this occurs and you attempt to load a TSO command processor under ISPF, then the ISPTCM version that is found first in a search will be the controlling ISPTCM.
Copyright © 2014 CA Technologies.
All rights reserved.
|
|