Starting Your Product › How to Configure Without CA CSM › Verify Your Installation

Verify Your Installation

Diagnosing problems caused by incomplete installation of CA OPS/MVS is difficult. Use the following checklists before starting the product to avoid such problems.

To verify your installation

1. Make sure the SYS1.PROCLIB (or the procedure library you copied the started task JCL procedures to) contains members OPSMAIN, OPSECF, and OPSOSF.
2. Make sure the OPSMAIN, OPSOSF, and OPSECF started tasks either have a STEPLIB that is authorized and contains all the load modules distributed with CA OPS/MVS or that all these modules are available in a LNKLSTxx load library or an LPALSTxx load library.
3. Make sure the Logical Parmlib Concatenation contains member OPSSPA00. Also check that the parameter values set by the OPSSPA00 member meet your requirements.
4. Make sure the library allocated to SYSPROC contains the OPSTART1 CLIST and OPSLOGON CLIST. OPSTART2 may be located in the SYSPROC or SYSEXEC.
5. If you are using the CA ACF2 command limiting feature, check that the entries listed in the table in Provide a CA ACF2 Command Limiting List in the chapter “Configuration Tasks for the Base Component” are present.

When the above items are verified, you are ready to start the product.