The ADDRESS WTO host environment produces these return codes:
The WTO/WTOR completed normally.
The WTO/WTOR TEXT keyword is missing.
The authorization check failed.
The DESC keyword cannot be used with the REPLY keyword.
The TEXTVAR keyword cannot be used with the REPLY keyword.
The HILITE and LOWLITE keywords are mutually exclusive.
The subsystem is not active and CA OPS/MVS is not running.
The length of the WTO/WTOR is greater than the allowed maximum.
The combination of the message text and MSGID specified exceeded the maximum length allowed.
A console ID is required with REG0/QREG0.
The WTOR timed out. No reply was received.
A WAIT was ended by an attention interrupt.
You must specify the CNID keyword in conjunction with the AREAID keyword.
You cannot use the AREAID keyword with the REPLY keyword.
An invalid value was specified for the ROUTE, DESC, or MCSFLAGS keyword.
A CLIST variable access error occurred.
A word tokenization error occurred.
TSO/E is not installed.
A command buffer parse error occurred.
The command processor is not authorized.
The authorization user exit abended.
A serious system macro error occurred.
A serious product control block error occurred.
You specified an invalid value for the CNNAME keyword.
The values specified for the CNNAME keyword is in conflict.
The MLWTO TEXTVAR variable was not found.
The value of the MLWTO TEXTVAR variable is too long.
Cross-system WTO request failed, MSF is not active.
Cross-system WTO request failed, none of the SYSIDs in the list are active.
A cross-system request cannot be completed. Check for error messages in the external data queue related to this error.
The message text for an AP WTO request contains an invalid character.
There are too many active remote systems.
The output message queue could not be allocated the for a cross-system WTO request due to insufficient virtual storage.
The OPTION keyword is in error. Either an invalid value was supplied or OPTION A or B was used with the REPLY or TEXTVAR keyword.
The SYSTEM keyword value of ALL is mutually exclusive with EXT.
The WTOID keyword is not allowed when specifying multiple consoles.
The NOLOG keyword may only be specified in AOF rules.
There was an abend %1 in the WTO function routine.
Note: Return codes greater than 1000 indicate a problem in the IBM WTO service. Since CA OPS/MVS adds a value of 1000 to IBM WTO return codes, you must subtract 1000 from the ADDRESS WTO return code and then review the IBM documentation for its meaning. IBM documentation normally lists the WTO macro return and reason codes in hexadecimal form.
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|