Host Environment Commands › ADDRESS OPSCTL Commands for the MSF › OPSCTL MSF Return Codes

OPSCTL MSF Return Codes

OPSCTL MSF commands produce these return codes:

4

For the MSF DEFINE command, the system definition failed. One of the following conditions occurred:

• The name of the system, an alias, or a VTAM APPLID you are trying to define already exists.
• Either a system by the same name is already defined or the name is an alias for an existing system.
• A failure (for example, a virtual storage shortage) occurred while attempting to allocate the storage necessary to represent the MSF system.

For the MSF DELETE command, no MSF system was deleted. One of the following conditions occurred:

• The system is not defined.
• The system is still active. Active systems must first be deactivated before being deleted.
• A failure occurred while freeing the storage associated with the MSF system being deleted.

For the MSF LIST command, no systems were listed because none have been defined.

For the MSF ACTIVATE command, the system was already active or is not defined.

For the MSF DEACTIVATE command, no MSF system was deactivated. This could mean that the system specified was already inactive or has not been defined.

For the MSF START command, some VTAM related failure occurred (see messages).

For the MSF STOP command, the local system has not been defined.

8

An OPSCTL MSF LIST command was issued, but the CA OPS/MVS product cannot perform the LIST request.

16

For the MSF START command, the local MSF system has not been defined or is already active.

24

Destination does not support SYSTEM() command.

40

No command output returned.

44

The CA OPS/MVS INITMSF parameter is currently set to NO.

Note: When the INITMSF parameter is set to NO (its default value), the RC value for all OPSCTL MSF commands is 44.

70

Current system not defined or active to MSF.

76

Error in command output processing.

80

The MSF request contained an invalid verb.

84

The MSF request contained a command syntax error.

88

An error exists in the tokenization routine.

92

Command disallowed during product termination.

93

The system name specified on an ADDRESS OPSCTL MSF DEFAULT command does not exist or is not active.

99

The sending system is considered non-secure.