POI Command Processors › OPSPARM Command Processor › Using OPSPARM to Display and Set Message Severity Codes › Change a Message Severity Code

Change a Message Severity Code

To change the severity code c to d for message OPSnnnnc, use this form of the OPSPARM command:

OPSPARM SET(OPSnnnn) VALUE('d')

Important! Before changing the severity code of any CA OPS/MVS message, see the chapter “Understanding CA OPS/MVS Messages” in the User Guide.

OPSPARM Installation Requirements

OPSPARM Utilization Environments

OPSPARM Sample Coding Statements