Using SSM Global Application › SSMGA Setup Requirements › Step 10: Activate SSM Processing and Verify the Setup

Step 10: Activate SSM Processing and Verify the Setup

After making all changes to an existing SSM configuration, you need to activate SSM processing and then verify that the setup is complete.

To activate SSM processing and verify the setup

1. Set the parameter STATEMAN as follows:

   STATEMAN=ACTIVE
   

   The SSM processing is activated.

   Note: SSMGA is not activated until the SSMSUBRULE parameter is set to SSMGAGBL. See Step 4 above, and section Using the SSM Subtask below.

2. Verify the setup by issuing the VERSYS command from the OPSVIEW 4.11.G panel.

   The SSMGA local setup is validated.