Preparing to Start Your Product › Started Task JCL Setup › SOLVE SSI Started Task Parameter Member

SOLVE SSI Started Task Parameter Member

The Install Utility generates the SSIPARM data set based on the values entered during the installation and setup process.

SSIPARM specifies the SOLVE SSI started task parameters.

Review the data set to:

• Ensure that the members meet your site-specific requirements
• Reapply any previous customization that is still required

Review the following members in dsnpref.NMC1.SSIPARM:

SSISYSIN

(Optional) (If you are using an existing shared SOLVE SSI region, you do not have to review this member.)

If SUBS=YES is set, you can update the SSISYSIN started task member to use z/OS static system symbols. System symbols assist in the planning of future deployment.

SSIPARMS

(Optional) (If you are using an existing shared SOLVE SSI region, you do not have to review this member.)

This member is present only if you created it when you specified the SOLVE SSI region.

Parameters can be shared with any other products using this SOLVE SSI. Review these parameters, and ensure that they are set correctly for the products (these parameters can be in SSISYSIN or SSIPARMS).

Note: For more information about sharing a SOLVE SSI, see the SOLVE Subsystem Interface Guide.