Installing Your Product from Tape › Installation JCL › Generate the Installation JCL

Generate the Installation JCL

During the installation process, you provide the site-specific installation information that you previously collected. This information is used to generate the installation JCL.

Follow these steps:

1. At the ISPF/PDF TSO Command Shell prompt, execute the following command:

   EXEC 'dsnpref.NMC1.CC2DJCL(INSTALL)'
   

   The Install Utility panel appears.

   Note: On each of the Install Utility panels, you can use the following keys:

   • Enter to proceed to the next panel
   • F1 to display online help
   • F3 to return to the previous panel
   • F4 to exit and return to the main menu
2. Press Enter.

   The Install Utility Primary Menu panel appears.

3. Enter 1 (Set Installation Parameters).

   The Software Delivery Method panel appears.

4. Complete each of the panels as they open. Press Enter at the completion of each panel.

   You must complete all five parameter panels before you can install the product. You can take the default options or specify site-specific values.

   Note: For information about the fields, press F1 (Help).

5. Enter 2 (Install Products).

   The INSTALLATION Primary Menu panel appears.

6. Enter 1 (Select Products to Install).

   The INSTALLATION Product Selection panel appears with previously installed products unavailable.

7. Enter S next to the product name and press Enter.

   The INSTALLATION Product Confirmation panel appears, confirming your selections.

   If you have already installed another product in the product family, the INSTALLATION Components Already Installed panel appears, confirming your selections.

   Note: You can enter S next to multiple products to install multiple products at one time. You must be licensed for any products you install.

8. Press Enter to confirm your selection, and complete each of the INSTALLATION panels as they open.

   You must complete all the panels before you can set up your regions. You can take the default options or specify site-specific values.

9. Record the data set name into which the JCL was generated in your post-installation worksheet.

   You can submit the jobs from the panel or directly from this data set after exiting the panel.

10. Submit and run the following installation jobs in sequence. Do not proceed with any job until the previous job has completed successfully.

    I01ALLOC

    Allocates the data sets.

    The I01ALLOC member allocates CC2DLOAD as a load library of the PDS type. Do not change it to a PDS/E type because the type is not supported.

    I02INSMP

    Initializes the SMP/E data sets.

    I03RCSMP

    Performs an SMP/E RECEIVE.

    I04AKSMP

    Performs an SMP/E APPLY CHECK. This job is listed only if maintenance exists for previously installed products.

    I05RSSMP

    Performs an SMP/E RESTORE. This job is listed only if maintenance exists for previously installed products.

    I06APSMP

    Performs an SMP/E APPLY.

    I07ACSMP

    Performs an SMP/E ACCEPT.

11. If you selected SSL Support as an additional feature to install, the following jobs are also generated. Submit and run them in sequence as for the previous jobs.
    • I21ALLME
    • I22INIME
    • I23RECME
    • I26APPME
    • I27ACCME

    Notes:

    • If you installed and set up your regions without SSL support, and then later install SSL support, add the installed dsnpref.NMC1.CC2DPLD data set to the region's STEPLIB or in the system LNKLST.
    • You must have SMP/E V3R5.0 to implement SSL.
12. Press F3.

    You are returned to the Primary Menu panel.