Setting Up Your ReportCenter Control Region › Generate the ReportCenter Control Region Setup JCL

Generate the ReportCenter Control Region Setup JCL

Note: If you use CA MSM to deploy the software on different systems before you perform the setup, you must use the Install Utility on a target system to perform the setup on that system.

Follow these steps:

1. At the ISPF/PDF TSO command prompt, execute the following command:

   EXEC 'dsnpref.NMC1.CC2DJCL(INSTALL)'
   

   The Install Utility panel appears.

2. Press Enter.

   The Install Utility Primary Menu panel appears.

3. (Optional) If you have installed the product using CA MSM, perform the following steps:
   1. Enter 1.

      The Software Delivery Method panel appears.

   2. Complete the panel:
      • Enter S next to CA MSM.
      • Specify the name of the CSI data set that is used during product installation in the SMP/E CSI Used field.
   3. Press Enter.
4. Complete each of the panels as they open. Press Enter at the completion of each panel. Complete all panels. You can take the default options or can specify site-specific values.
5. From the Install Utility Primary Menu panel, enter 5 (Setup a Product Region).

   The SETUP Product Region Primary Menu panel appears.

6. Enter 4 (Add products and/or additional features to a region).

   The SETUP Specify Product Region Source panel appears.

7. Enter S next to the region you want to make a ReportCenter control region.
8. From the SETUP Additional Products Selection panel, enter S next to ReportCenter.

   Important! Do not set up any other products or features at the same time as ReportCenter; do these setups separately.

9. Complete each of the SETUP panels as they are displayed.

   The SETUP JCL Library Creation panel asks you for a name for the Setup JCL data set.

   The installation process places the generated setup jobs in this data set. If you installed from tape or with ESD, the default name is dsnpref.NMC1.rname.JCL, where rname is the region name. If you installed with CA MSM, the default name is dsnpref.rname.JCL. To ensure that ReportCenter has its own dedicated setup JCL data set, change this name to another name, such as dsnpref.NMC1.rname.JCL.WR. Note the name.

   Note: For more information about the fields, press F1 (Help).

10. When the SETUP JCL Library Generation panel appears, press Enter.

    The JCL is generated.