|
|
|
It is possible that an unlisted return code is an obsolete return code from a previous release of your TCP/IP product.
storage failure
Determine why the address space is experiencing storage problems
socket failed
See SOCERRN code
sendto failed
See SOCERRN code
recvfrom failed
See SOCERRN code
bind failed
See SOCERRN code
listen failed
See SOCERRN code
accept failed
See SOCERRN code
getclientid failed
Contact Technical Support.
send failed
See SOCERRN code
receive failed
See SOCERRN code
socket_ID invalid
Check the ID= parameter on the &SOCKET verb
connect failed
See SOCERRN code
invalid data
Contact Technical Support
attach failed
Contact Technical Support
gethostbyname failed
See SOCERRN code
subtask terminated or abended
Check whether a TCPIP STOP has been done; otherwise contact Technical Support
setsockopt failed
See SOCERRN code
invalid IP address specified
Specify valid IP address
MDO error: see &ZMDORC and &ZMDOFDBK
Note: For more information, see the Network Control Language Programming Guide.
Request has been flushed
Investigate why the NCL procedure was flushed and restart if required
getsockname failed
Contact Technical Support
hopnumber too low
Increase the number of hops specified on the Trace TCP/IP Route panel
givesocket failed
Contact Technical Support
takesocket failed
Contact Technical Support
gethostbyaddress failed
See SOCERRN code
Invalid NCL ID
Specify valid NCL ID
Ping request not accepted
See SOCERRN code
Traceroute request not accepted
See SOCERRN code
Buffer overflow occurred
Supply smaller amount of data
MDO too large
Decrease number of pings or hops
TCP/IP QUIESCE command entered
No action
socket being closed
No action-socket closed or process flushed
invalid request
Contact Technical Support
socket interface not initialized
Issue the TCPIP START command from OCS
| Copyright © 2009 CA. All rights reserved. |
|