Preparing to Start Your Product › Started Task JCL Setup › Started Task Parameter Members

Started Task Parameter Members

The Install Utility generates the following members, based on the values you entered during the installation and setup process. Review these members to ensure that they meet your site-specific requirements; if necessary, reapply any previous customization that is still required:

• Product region started task member dsnpref.rname.TESTEXEC(RUNSYSIN)

  To assist you in planning future deployment, you can update the RUNSYSIN started task members to use z/OS static system symbols if you have set SUBS=YES in the member.

  Note: For more information about JCL parameters, see the Reference Guide.

  If you do not want SYS1.DUMP data sets for dumps, remove the parameter PPREF='XOPT=SDUMP' and add the SYSMDUMP DD statement to the generated task in dsnpref.NMC1.rname.JCL(rname).

  If you want to use a migrated INI file, uncomment the PPREF='INIFILE=????????' parameter and replace the question marks with the name of the INI file.

• Product region parameter members in dsnpref.rname.TESTEXEC:
  • NMREADY
  • NMINIT

  Note: If you do not have other CA NetMaster products in this region, you must activate INMC links in NMREADY.

  You can activate these links now or later.

  Note: For more information about the INMC feature and INMC LINK definition parameters, see the Reference Guide.